Subaru Forester 2013-2014 SJ

Headunit Installation Requirements

You will need

Facia - Single DIN : 

Required

Facia - Double DIN: 

Required

Steering Wheel Control Harness: 

Required, also requires radio brand specific patch lead

Primary Harness: 

Required, may require a secondary harness

Antenna Adaptor: 

Required

Additional Products

T Harness (for adding aftermarket bluetooth car kits): 

Available

Manufacturers headunits can vary slightly for this vehicle, please select yours for best results:

Clarion Factory Headunit

Fujitsu(Denso)10 Headunit

Images
About this Vehicle

Dates: 

Jan 2013 through Jan 2014

Manufacturer: 

  • Subaru

Sub-Model: 

S4

Chassis Type: 

  • 4x4
  • Wagon

Place of Origin: 

Japan

Tags: 

  • 4x4
  • Wagon
  • Cross-over
  • Subaru
  • Forester
  • SJ
  • S4

Subaru Forester

The fourth generation Subaru featured

  • Continuously Variable Transmission (CVT) and decreased towing capacity. Maximum towing capacity was reduced to 1,500 pounds across all trim lines. XT (turbo) variants use a high-torque CVT with steering wheel paddle shifter controls.
  • Revised, sport-oriented suspension, wheels (18-inch) and chassis bracing for XT (turbo) variant, providing flatter cornering in turns and better handling overall with little impact on ride.
  • Increased fuel economy, up to 32 mpg highway (EPA rated)
  • 1.4 inches longer, 0.6 inches wider, 1 inch longer wheelbase
  • Increased interior volume: rear seat legroom is 41.7 inches and rear cargo volume (with seats folded down) is 74.7 cubic feet.[22]
  • New option on higher end only models is "X-MODE" AWD control system, which was developed for the driving on uneven or slippery road condition. Engine, Transmission and VDC are controlled cooperatively.[23][24]
  • New option on top of the line 2.5i and 2.0XT Touring models only: Eyesight Driver Assist System

Information provided by: http://en.wikipedia.org/wiki/Subaru_Forester#Third_generation_.28SH.2C_2008.E2.80.932013.29

Wiring Information
The Amp trigger is the 2nd Antenna trigger wire (From olden days, but no longer used).
So, From the right - Illumination, Amp Trigger, Ant Trigger, GND, etc
Thanks Marty

Speaker Cavities
Front Tweeter 1"
Front 6-1/2"
Back 6-1/2"